Create Account
Search
You are here: TDG Forum  >>  Texas Instruments SOMs and Development Kits  >>  OMAP-L138 eXperimenter Kit  >>   Which pins connect to user LED1 and LED2 on the board?

Technical Discussion Group Forum

This forum is provided for user discussion. While Beacon EmbeddedWorks support staff and engineers participate, Beacon EmbeddedWorks does not guarantee the accuracy of all information within in the Technical Discussion Group (TDG).

The "Articles" forums provide brief Articles written by Beacon EmbeddedWorks engineers that address the most frequently asked technical questions.

To receive email notifications when updates are posted for a Beacon EmbeddedWorks product download, please subscribe to the TDG Forum of interest.

TDG Forum

PrevPrev Go to previous topic
NextNext Go to next topic
Last Post 05 Sep 2013 04:26 PM by  Michael Jordan
Which pins connect to user LED1 and LED2 on the board?
 2 Replies
Sort:
You are not authorized to post a reply.
Author Messages
manik.singhal@gmail.com
New Member
New Member
Posts:


--
03 Jan 2013 02:16 AM
    Hi,
    I am unable to figure out which pins of the SOM-M1 connect to the user LED1/LED2 on the experimenter kit.
    The LEDs are labelled as D1/D2, but i can't figure out which of the (possibly GPIO) pins these are.

    Is the documentation insufficient or is it very obvious for embedded developers?

    Regards
    Manik
    richh@logicpd.com
    New Member
    New Member
    Posts:52


    --
    29 Mar 2013 04:04 PM
    Manik,
    User LED 1 and User LED 2 are on D2/D3. They are tied to an I2C I/O expander located on the same schematic page, U9, at PO7 and PO6.
    Michael Jordan
    New Member
    New Member
    Posts:1


    --
    05 Sep 2013 04:26 PM
    You will have to get the datasheet for the TCA6416. You have to send bytes over I2C to enable the needed outputs, then send bytes to turn the outputs on and off. Be careful though. The board reset is also connected to the same output bank. Enable that and you will have to hit the power switch to reboot before you will be able to get the board running again.
    You are not authorized to post a reply.

    Forums Texas Instruments SOMs and Development Kits OMAP-L138 eXperimenter Kit