Create Account
Search
You are here: TDG Forum  >>  NXP SOMs and Development Kits  >>  LH7A400 Card Engine and Development Kit  >>   Problem booting up.

Technical Discussion Group Forum

This forum is provided for user discussion. While Beacon EmbeddedWorks support staff and engineers participate, Beacon EmbeddedWorks does not guarantee the accuracy of all information within in the Technical Discussion Group (TDG).

The "Articles" forums provide brief Articles written by Beacon EmbeddedWorks engineers that address the most frequently asked technical questions.

To receive email notifications when updates are posted for a Beacon EmbeddedWorks product download, please subscribe to the TDG Forum of interest.

TDG Forum

PrevPrev Go to previous topic
NextNext Go to next topic
Last Post 05 Feb 2004 11:24 AM by  Anonymous
Problem booting up.
 1 Replies
Sort:
You are not authorized to post a reply.
Author Messages
lawriekurian@greymatterindia.com
New Member
New Member
Posts:


--
03 Feb 2004 07:49 AM
    Hi all,

    We are facing a problem while powering up the board SDK-LH7A400-10.
    We are not getting the prompt on the tera terminal as per the user manual.

    We have done the settings according to the manual to as follows:
    Baud Rate: 115200
    Data Bits: 8
    Stop Bit: 1
    Parity: None
    Flow Control: None

    Even the jumper settings are in Normal Mode.

    On power up the STATUS LED 0 glows.

    Any help would be highly appreciated.

    Thanx in advance.
    Anonymous
    Posts:


    --
    05 Feb 2004 11:24 AM
    Hello Lawrileo,

    Thanks for your question. Can you please provide the following information:

    1. Part and Serial numbers from Card engine and SDK Application board. The part number is in the form 80000xxx-xxx. Serial number is xxxMxxxxx.

    2. Distributor you purchased product from.

    3. Look on application board. Is C36 populated? If it is are you pressing the NMI-Wakeup button (S2)? The board will not start up without this.

    4. What is the position of the JTAG jumpers (what are J6.1.3.5 and J6.2.4.6 set to)?

    5. Is the card engine inserted properly? The expansion connectors on the
    back side of the card engine must be seated properly to the SDK application board. Please remove and reinsert the card engine following the Quickstart Guide Card Engine installation and removal instructions.

    6. Voltages: please verify the following voltages are present on the board:
    pwr supply: 5 V
    LM317: VCore (1.75V)
    LM1086: 3.3V

    Please also check the regulators for signs of shorts. If you have an emulator you can connect up and attempt to communicate.

    Please let me know what you find out

    Best Regards,

    Andrew Wawra
    Logic Product Development
    You are not authorized to post a reply.

    Forums NXP SOMs and Development Kits LH7A400 Card Engine and Development Kit