Go to previous topic
Go to next topic
Last Post 03 Jun 2014 08:42 AM by  bradb
Error in connection to OMAP-L138
 1 Replies
Author Messages
John Papanikolaou
New Member
New Member
Posts:2


--
28 May 2014 06:32 AM

    Hello,

     

    We have been working with the OMAP L-138 Kit but suddenly we faced the following ERROR when trying to connect:

    -----------------------------------------------------------------

    "Error connecting to the target:
    (Error -2131 @ 0x0)
    Unable to access device register. Reset the device, and retry the operation. If error persists, confirm configuration, power-cycle the board, and/or try more reliable JTAG settings (e.g. lower TCLK).
    (Emulation package 5.1.450.0)"

    -----------------------------------------------------------------

    We have tried the recommended actions but the problem remains. What should we do? 

     

     

     

     
    bradb
    Basic Member
    Basic Member
    Posts:203


    --
    03 Jun 2014 08:42 AM
    John,

    There is a similar post

    on the TI E2E.  The response from the Rafael at TI was the following:


    "The fact the emulator says it can't connect to the ICEPICK_D indicates the connection is not related to any GEL files (internally the ICEPICK_D is a JTAG component that is connected before any core). That said, it is possible the connection is physically ok but the emulator device driver is not able to properly communicate with the emulator because of the use of the virtual machine - at least we experienced several related issues and inconsistent behaviour with the boards and emulators here.

    If you are able to install CCS in the host Operating System (not VM) and connect successfully, I think the solution is either to try to use a different virtual machine vendor or use it in a different PC with native Linux."

     

    Forums Texas Instruments SOMs and Development Kits OMAP-L138 eXperimenter Kit
    ---