Go to previous topic
Go to next topic
Last Post 28 Nov 2005 10:06 AM by  Anonymous
LogicLoader doesn't appear
 1 Replies
Author Messages
svroy
New Member
New Member
Posts:


--
25 Nov 2005 09:26 AM
    Hi everybody,
    I am new to this community

    I'm student and doing a project on embbeded and pda application.

    I started the Zoom Sharp Kit yesterday and after checking serial settings, all cable connections and board connections, the LogicLoader screen will not appear. I have also checking the Host configuration (x86 on WinXP PRO), the null-modem serial cable, the power (~5 V DC) and Tera Pro.

    Is the Logicloader corrupted ? Is there another solution than using a JTAG emulator to restore it?

    I have let the JTAG jumpers on normal settings.

    Thanks a lot,
    Stéphane
    Anonymous
    Posts:


    --
    28 Nov 2005 10:06 AM
    Hello Stephane,

    The most likely cause for this is that the card engine is not connected correctly to the SDK Application Board. Please verify that both of the 80 pin connectors on the underside of the card engine are firmly connected to the application board. You may have to press firmly before you feel the connectors click into place.

    Also please verify that your TeraTerm serial port settings are correct.

    Regards,

    Forums NXP SOMs and Development Kits LH7A404 Card Engine and Development Kit
    ---