newuserNew Member Posts:22
03 Nov 2005 09:30 AM |
|
Hi
I can’t seem to make a boot-time script work. Here is the command I used to store the script into eeprom:“losh> echo “VOVOhelp dir; info mem; exit;” /dev/serial_eeprom”. I then used the “cat” to confirm the script. When I reboot the Fire Engine board all I see is the standard power-up messages. What is wrong with the script?
newuser
|
|
|
|
kurtl@logicpd.comNew Member Posts:
03 Nov 2005 11:50 AM |
|
Try "VOLOhelp instead of "VOVOhelp.
Also, what version of Lolo are you using? Some older revisions didn't support the Volo command.
|
|
|
|
AnonymousPosts:
03 Nov 2005 12:03 PM |
|
Hello,
In the case that the version of LogicLoader that you're using is older than 2.0.x you can use "LOLO" instead of "VOLO". However it is recommended that you update to the latest version of LogicLoader.
Thanks,
|
|
|
|
newuserNew Member Posts:22
03 Nov 2005 01:12 PM |
|
Thanks
|
|
|
|