Hello Epiphany,
Yes, the LED's should be flashing back and forth.
Please verify the following:
- Has the bootloader been overwritten? Did you write an application to reside in block 0 of flash?
- J6 JTAG jumpers are in the correct position
- the card engine is being supplied with 5 volts
- the card engine is seated correctly. (remove and reinsert card engine, view from side to verify the expansion connectors on the backside of the card engine are correctly mating to the application board.
- The regulators are supplying the correct voltage and are not burned out.
Please get back to me with the information.
Best Regards,
Andrew Wawra
Tech Support
Logic Product Development
|