Go to previous topic
Go to next topic
Last Post 13 Jul 2004 12:09 PM by  shahjayesh
Download / Initialize can't find device
 2 Replies
Author Messages
shahjayesh
New Member
New Member
Posts:


--
13 Jul 2004 11:42 AM
    Hi,

    When I build the image and then try to Download it..PB can't find my device. I'm able to ping the device from my computer but PB can't see it and if I give the device name it accepts the name but doesn't start the downlaod. PB keeps waiting for Bootme from the device.

    I had it working earlier but then I installed WinCE 5.0 and the BSP didn't work and since the new BSP aren't ready I uninstalled 5.0 but now my WinCE 4.2 doesn't connect to device for download and I have tried reinstall and cleaning the registry and all of those to see if it helps but no luck!!

    Thank you,
    Jay
    Anonymous
    Posts:


    --
    13 Jul 2004 11:58 AM
    shahjayesh,

    Can you post what you're sending as a bootscript? What do you have your network connection settings at? i.e IP address, netmask, etc...

    Also have you adjusted your settings under Target | Configure Remote Connection in Platform Builder?

    The more info you give me the easier it should be to track this down.
    shahjayesh
    New Member
    New Member
    Posts:


    --
    13 Jul 2004 12:09 PM
    Hi Aaron,

    Following is the clipboard copy of Tera Term.

    **********************************************************
    losh> ifconfig sm0 dhcp
    Starting DHCP on sm0
    losh> ifconfig

    sm0: up 10M half-duplex (413)
    sm0: mac: 00:08:ee:00:41:d3 ip: 10.95.21.87
    mask: 255.255.252.0 gw: 10.95.20.1

    *******************************************************

    I would then type bootme & at the prompt. Term Term then shows the Device name and starts printing Sent BOOTME.

    I did configure settings under Target | Configure Remote Connection in PB and its set both the Download and Kernel Transport to Ethernet.

    Thanks.


    ---