Go to previous topic
Go to next topic
Last Post 08 May 2008 03:32 PM by  sampath
UEC on MPC8360ERDK
 0 Replies
Author Messages
sampath
New Member
New Member
Posts:


--
08 May 2008 03:32 PM
    Peter,

    I have configured the ethernet PHY as generic MII and link comes up correctly. I have virtually unmodified uec.c and uec_phy.c and yet I do not see the frames on the wire. I loopback UEC0 and UEC1 with a crossover cable. I see the frames leave the TX BD FSL UEC0 without error but the RX BD on the FSL UEC1 does not see the frame.

    Is it a problem to configure the BCM 5481 are generic MII? I thought that will limit other features like interrupt on change in link status but will work otherwise.

    Sampath


    ---