I am currently holding the EVM with Micron discontinued MT29F4G08AACWC:C chip on board. i got part from Micron with replacement MT29F4G08ABADAWP:D. I started to load the part on the board and encountered write operation failed especially seeing bad block occurring in the nand. I can't figure out what is going on and hope to get some advise and i believe LOGICPD should facing the same problem as i am. As a result hope you can share with me the solution.
1) Does this replacement requires any software changes?
2) Any major parameter changes between this two part?
Info:
Oeprating system: Wince 6.0R3
BSP:BSP_WINCE_ARM9_01_10_00
hardware: AM1808 EVM kit
Keng